All calculators

Staircase Calculator — Straight, L & U Room Fit

Compare straight, L-shaped and U-shaped stairs against your available room. Check riser splits, rotation, excess and straight-flight headroom in inches or millimetres.

“Fits” checks only the available rectangular room. Approach and exit space, doors, railings, structure and building regulations require separate review.

Straight staircase

Fits the available room

16 risers of 6.89 in · 15 treads of 11.02 in

Room 35.43 in × 177.17 inStairs 35.43 in × 165.35 in · 0°
Blue: available room · Beige: flights · Green: landings · Arrows: upward. Footprint only; approach and exit space are excluded.
Side viewFloor-to-floor height 110.24 in16 risers · 15 treads
The upper floor forms the final step.
Riser / going
6.89 in / 11.02 in
Step measure 2R + G
24.8 in
Pitch
32.01°

Flight 1: 16 risers, 15 treads, 165.35 in run.

Floor opening above the straight flight

Minimum headroom: 81.69 in · target met. Minimum opening for the target above this flight: 132.28 in.

Approach floor clearance: 102.36 in. The opening ends at the upper floor and spans the full stair width. Slab thickness 7.87 in; target 78.74 in.

Your room

From finished floor to finished floor.
Clear rectangle in plan view.
Without doors or other obstacles.
Adjust planning dimensions

These are planning preferences, not code limits. Going stays unchanged across all proposals.

Same for every shape.
Horizontal distance between the front edges of adjacent treads.
Preferred height of one riser.
Lower bound for the whole-count search.
Upper bound for the search.
At least the stair width. L: square; U: across both flights.
Only for the U-shaped layout.
From the upper landing along the flight.
Horizontal ceiling; opening spans the full stair width.
A planning target, not a code-compliance claim.
Proposals rank first by fitting footprint, then preferred riser. Unequal flights are possible.

Try the examples
How the planner works

Which staircase fits your room?

Compare a straight flight and two layouts with landings. The same floor height and planning dimensions produce three visible proposals.

Risers, going and landings

Risers, going and landings

Floor-to-floor height divided by the whole riser count gives the actual riser. A straight flight has one fewer tread: the upper floor forms the final step. Two flights with a landing have two fewer treads than risers.

A flight with n risers needs (n − 1) × going of horizontal run. The L layout uses a square landing. For U, the longest flight controls length; width includes both flights and the gap. The planner searches every whole count within your bounds and every allowed split. Going is never reduced to force a fit.

Headroom is measured at the highest covered tread under the slab, not along an imagined sloping line. The opening starts at the upper landing. An opening across the entire flight has no ceiling above it to measure. Approach and exit geometry need separate review.

The examples illustrate planning scenarios, not required dimensions. This tool plans straight treads and rectangular landings only: no winders, spirals, stringer cutting or structural design. Floor height is capped at 6 m and 120 risers. Preferred riser can range from 50 to 400 mm and going from 50 to 1,000 mm: arithmetic bounds, not recommended dimensions.

Check current local requirements and the full site with a qualified specialist. This calculator compares planning geometry and does not certify code compliance.

Rate this calculation

Text copied
Removal error
Restore error
Calculator published
Calculator unpublished
Feedback sent
Done
Error
Author received:++
Calculator removed

Install as an app

Open the browser menu and choose “Add to Home Screen” or “Install app”.